Managing the projector using a web browser
Once the projector is connected to a wired local area network and the projector is on or
in standby mode, you can use any computer that is in the same network to manage and
control the projector via BenQ Projector Control System accessed through the
computer's web browser.
Supported web browsers
Make sure you are using one of the following web browsers:
•
Internet Explorer: 9 / 10 / 11
•
Chrome: 55.0 / 56.0 / 57.0
•
Safari: 8.0 / 9.0 / 10.0
•
Firefox: 50.0 / 51.0 / 52.0
Configuring
In order to control the projector remotely while the projector is in standby mode, you
need to enable the Network Standby Mode and Monitor Out settings for the projector. To
do so, follow the steps below:
1.
Press MENU on the projector to open the Advanced Menu options.
2.
Highlight System and press OK.
3.
Highlight Standby Settings and press OK.
4.
Highlight Network and press OK.
5.
Highlight Enable Network Standby Mode and press OK.
6.
Select On then press OK.
7.
Press BACK to return to Standby Settings.
8.
Highlight Monitor Out and press OK.
9.
Select On then press OK.
Accessing the BenQ Projector Control System
1.
Make sure your computer and the projector are connected to the same local area
network. See
2.
Launch the web browser on your computer.
3.
Enter the IP address of the projector in the browser's address bar and press the
computer's Enter key.
30
Managing the projector using a web browser
Standby Settings
"Wired connections" on page 6
for the projector
for details.