Installation
j) If the finger board comes in contact with the
rollers while they are turning, contact your
service representative to adjust the PHOTO-
EYEs.
k) Slide the "finger board" towards the roller nip
about center of the front feed table.
fin g e r b o a rd
l) The rollers should stop just before the finger
board can enter the roller nip.
m) Slide the finger board back away from the rollers
nip. Press the motor engage/ disengage to
ENGAGE.
(disengage)
n) If the finger board comes in contact with the
rollers while they are turning, contact your
service representative to adjust the PHOTO-
EYEs.
Page 4 - 16
F 60 H Operation and Maintenance Manual
(engage)
© April 2001 General Binding Corporation
o) Slide the "finger board" on the front feed table
towards the nip about ten in. ( 25 cm ) from the
control side.
fin g e r b o a rd
p) The rollers should stop just before the finger
board can enter the roller nip.
q) Slide the finger board back away from the
rollers nip.
r) If the finger board comes in contact with the
rollers while they are turning, contact your
service representative to adjust the PHOTO-
EYEs.
s) Raise the main roller.