Page 1
1. Before using your laminator, read and understand the machines instruction manual and the user’s guide 2. Never feed empty pouches into machine 3. Do not leave laminator unattended during lamination 4. Turn off your laminator when not in use 5.
Page 2
Before laminating, read and understand the machines instruction manual and the user’s guide. Use the machine only for its intended purpose Use quality pouches. Pouches used in GBC laminators must have a minimum level of stiffness which some lower quality pouches do not provide...
Page 3
No Power to Machine Check power cord is plugged in properly Check power is turned on at power point and at machine (on /off switch) Machine not heating up Check power to machine (as above) Leave machine on for a few minutes longer than instructions indicate Try a different heat setting (where available) Pouch Jamming If the document has an end outside the laminator, turn the machine off and push the release lever.
Page 4
Is maintenance of the machine needed? If the laminator is used correctly with GBC Pouches, machine maintenance is not necessary. Cleaning of the rollers is recommended after every laminating session. To clean roller, run a sheet of white cardboard through...
Page 5
My pouch box says 125 micron – is this the total thickness of the pouch? GBC always states the thickness per flap so a 125 micron pouch is 250 micron total thickness. Some other manufacturers state total thickness so their 250 micron pouch would equal the total thickness of GBC 125 micron pouch.