Safety Precautions - GBC F-60H Operation & Maintenance Manual

Safety

1.2 Safety precautions

The Falcon 60 H laminator has been designed
with safety as a primary consideration; however, you must
become thoroughly familiar with the controls, proper
operation, proper service procedures and safety features
of the laminator before using or servicing the unit.
The manual main roller lift mechanism used to
provide downward pressure on the upper main roller is
capable of producing forces greater than 400 pounds.
This force is applied to any object presented in the opening
( called the nip ) between the two rollers.
Use care in lowering the upper laminating roller
and know how to react quickly in an emergency. The
main laminator roll up / down control is located on the
right side of the machine within the front. Before turning
the crank handle to set the GAP down, ensure that nothing
is in the nip area.
K eep hands and fingers clear of the
lam inator roller nip w hen adjusting nip.
Y ou can be C R U SH E D or B U R N E D !
In addition, the main laminating rollers of the
Falcon 60 H can reach temperatures up to 200
Page 1 - 2
W AR N IN G
o
F (100
F 60 H Operation and Maintenance Manual
At these temperatures there is a danger of
severe burn if the rolls are touched during
setup, operation or servicing.
The word qualified is defined below;
Qualified;
• Any engineer that has experience with electrical
and mechanical design of lamination equipment. The
engineers should be fully aware of all aspects of safety
with regards to lamination equipment.
• Any commissioning or service engineer must be
of competent nature, trained and qualified to GBC Films
Group standards to fulfill that job. This person will have
completed and passed the full service training course from
GBC Pro-Tech.
• Any GBC Technician, GBC Specialist, and / or
GBC Films Group Technician that has been through the
GBC Pro-Tech service training course.
o
C).
© April 2001 General Binding Corporation
DANGER