Teledyne T300 Operation Manual page 127

Teledyne API – Model T300/T300M CO Analyzer
NOTE:
ANALOG OUTPUTS
configured for 0.1V full
scale should always be
calibrated manually.
Toggle this button
to turn AUTO CAL
ON or OFF
(OFF = manual
calibration mode).
06864B DCN6314
From the
AIO CONFIGURATION SUBMENU
DIAG ANALOG I/O CONFIGURATION
PREV NEXT
DIAG AIO AOUTS CALIBRATED: NO
SET> CAL
Continue pressing SET> until you reach the
output to be configured
DIAG AIO CONC_OUT_2: 5V, OVR, NOCAL
<SET SET> EDIT
DIAG AIO CONC_OUT_2: RANGE: 5V
SET> EDIT
Continue pressing SET> until ...
DIAG AIO CONC_OUT_2: AUTO CAL.:ON
<SET SET> EDIT
DIAG AIO CONC_OUT_2: AUTO CAL.:ON
ON
DIAG AIO CONC_OUT_2: AUTO CAL.:OFF
OFF
ENTR EXIT
EXIT
EXIT
EXIT
EXIT
ENTR accepts
the new setting.
EXIT ignores the
ENTR EXIT
new setting.
ENTR EXIT
Setup Menu
125