Testing The Alarm; Automatic Call After Alarm; System Profiles Status Indications - Avaya 3735 User Manual

Menu operation

Testing the alarm

Procedure
Press and hold the alarm button until the system displays the information text Test Alarm.
• A beep is heard.
• The vibrator stirs.
• The handset receives a notification that the alarm has been received by the system. This is a
system dependent feature.
• An acoustic location signal (ALS) is played.
• A call to a predefined number is established.
When the vibrator is enabled, the handset alternates between the vibration and the sound. The
vibration and sound are not activated simultaneously. The system does not play the ALS, if the
Automatic call after alarm option is enabled.

Automatic call after alarm

A handset can be configured to call a predefined number after an alarm has been sent. If
configured, it is also possible to call the predefined number without sending an alarm by pressing
the push-button. Depending on the settings, the call can be established in the following modes:
• Loudspeaking mode
• Normal mode
• Monitor mode

System Profiles Status Indications

The administrator can configure the handset to play a sound if the system profile is activated or
deactivated. This provides the user with an audible alert when the system profile changes from
inactive to active or vice versa. The feature can be triggered by several kinds of events, such as
moving between different parts of a buildings where a system profile might be appropriate in one
location but not required in another. The system profile name is displayed when the handset is in
idle mode. The user should be aware that the characteristics and behaviour of the handset change
when the system profile changes.
July 2017 Using Avaya 3735 DECT handsets connected to Integral Enterprise IEE 7.2
Comments on this document? infodev@avaya.com
70