Transferring A Call To The Bluetooth Headset; Switching To A Headset With A Cord; Operation Notice - Avaya 3735 User Manual

2. Select Audio transfer.

Transferring a call to the Bluetooth headset

About this task
Use this procedure for transferring a call to theBluetooth headset while you are on call with the
handset.
Procedure
1. Press More.
2. Select Audio transfer.

Switching to a headset with a cord

Before you begin
You must on a call.
Procedure
To transfer the call to the headset automatically, connect the headset with a cord.

Operation Notice

Accessibility and voice quality
The base network is not always available. If you cannot connect with your system, contact your
system administrator. For best voice quality, avoid positioning near computer, radio or similar
equipment.
Operating area
You can only use your cordless handset in the area that is covered by your system. Outside this
area, you will loose contact with the system. The signal strength icon will be low and Searching is
displayed.
Out of Range
When you leave the system's coverage area a short beep will sound and Searching is displayed.
The out of range beep is repeated every minute for 30 minutes. The sound can be turned off by long
pressing the Sound off (
Depends on the configuration by the administrator.
When re-entering the coverage area it can take a couple of minutes before the handset
automatically has registered into the system.
July 2017
) key , or
Using Avaya 3735 DECT handsets connected to Integral Enterprise IEE 7.2
Comments on this document? infodev@avaya.com
.
Operation Notice
45