Table of Contents
Advertisement
3
Adjust the image .
• After exposure, adjust the image as required.
4
Press [
] .
• The exposure is completed, and the display re-
turns to the initial screen .
••••• ••••••••••••••••••••••••• •••••••
IMPORTANT
• When consolidating image adjustment, press [
pause the examination and return to the initial screen.
•• • •• •• • •• •• •••••••••••••••••••••••••••••••••••••••••
7.2 Exposure with AeroDR Portable RF Unit2
7 .2 .6
Operations after
exposure
Operations after an exposure has been completed is
performed according to the following procedure . After
returning to the institution, output image data saved on
this device to the host system . The following procedure
is for an example in which a wired connection is in op-
eration between this device and a higher system .
1
Turn all the devices off.
• For information on how to shut down each de-
vice, refer to "AeroDR Portable RF Unit2 Opera-
tion Manual" .
2
Place each device in the carrying case .
• For information on how to store each device,
refer to "AeroDR Portable RF Unit2 Operation
Manual" .
3
Return to the institution.
4
Connect this device to the institution net-
work using an Ethernet cable .
] to
• On connection, the icon of [System] will change.
IMPORTANT
• Do not disconnect the Ethernet cable while the data is
being transmitted .
• The status of communication with the host is displayed
on the [System] button. For detail, refer to "7 .2 .1
Screen structure" .
•• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• •• •• ••• •• • • • •
5
Charge this device and the DR Detector.
• For information about the operations of the DR
Detector, refer to "AeroDR Operation Manual" .
213
• ••• •• •• •• ••• •• •• •• •• ••• •• •• •• ••• • • • •
Advertisement
Table of Contents
