Table of Contents
Advertisement
Displayed message
Cannot read the magnetic card .
Restart the system .
Changed parameters have not been saved . Are you sure you
want to discard them?
Changing patient information may cause errors in PACS study
matching. Confirm all changed data immediately on PACS.
Channel change is not required for wireless access point .
Connected successfully .
Copying ...
Could not find the matching Order to apply the exposure results.
Please check .
CR mode (Free) will be active!
CS-7 AEROSYNC license is not registered . Please register for
the license .
CSV OutPut Successfully saved .
Data Already Present . Please Change Media
DB data got udapted, Updated Study will be displayed .
DB Error - Create order failed .
Deleting of the job is not success .
Destination setting is invalid .
This study is not shared, and suspended .
Device cancellation failed .
Different digit serial numbers can not be configured.
Digit Serial Number or Time is not configured to Patient ID.
Every time same Patient ID will get generated . Is it OK?
Do you want change the body size, Please confirm?
Do you want to abort the calibration process?
Do you Want to append shot to the Study?
Do you want to change the Detection Algorithm setting to OFF ? This is displayed when changing the detection selection pro-
8.2 Dialog boxes/balloons and countermeasures
Problems/countermeasures
This is displayed if an error occurred when a magnetic card is
read .
Displayed when [Back] is pressed with without pressing [Apply]
after making edits on the stitching viewer screen. Press [OK] to
close without saving the edits .
This is displayed when the patient information is modified after
starting the study .
This is displayed when there is no necessity to change the
channel settings of the wireless access point .
This is displayed when the connection is confirmed as a result
of the ping diagnosis .
Image copying in progress . Wait until the process end .
This is displayed when there is no Exam. Tag to apply the expo-
sure result from the X-ray device .
Displayed when set to non-interlock with the X-ray device .
To return to the sync setting, press [OK] or [Use XG-Sync].
(When S-SRM X-ray Exposure sync mode is set to Manual)
Displayed when using the Aero-Sync mode exposure func-
tion on a console with the device's unregistered AEROSYNC
license .
Register the device's AEROSYNC license .
Displayed when CSV output is complete .
This is displayed when appending to written media is not pos-
sible .
Displayed when updating a study while it is in operation . Check
the content details .
This is displayed when a new study cannot be created .
This is displayed when stopping of JM read has failed .
The moving process was not performed because the destina-
tion settings were not correct .
Check the destination settings .
Displayed when canceling the DR Detector registration from the
exposure room has failed.
Displayed when setting the Start value and Stop value with dif-
fering numbers of digits .
Set link numbers with the same number of digits .
The patient may be recognized as an identical patient on each
occasion .
Set the link number settings and time settings .
This is displayed when a child patient size is changed to other
patient size in the [Exp. Info] tab.
This is displayed when aborting calibration .
Press [OK] to abort.
This is displayed when adding exposure to studies.
Press [OK] to add exposure.
cessing setting from ON to OFF .
Press [OK] to turn OFF the detection selection processing.
359
Continued on the next page
Advertisement
Table of Contents
