Resetting The Module To The Factory Default Values - 3Com SuperStack II 3300 User Manual

Restarting the
Module
Resetting the
Module to the
Factory Default
Values
If an incomplete or corrupt application image is loaded into the Layer 3
Module, the module boots up into the Configuration Application.
When the image is read it is applied to the non-volatile storage on the
Layer 3 Module.
The following prompt is displayed:
Applying software update.............................
Download operation completed successfully.
Press RETURN key to continue
The application image has now been downloaded.
Option 4 is provided for 3Com support purposes only.
4 Enter to return to the Configuration Application Menu Display.
0
1 Enter to exit the Layer 3 Module.
3
2 To restart the module, do one of the following:
Power down and then power up the Switch.
Use the
system reset
To use this command:
a Use Telnet to access the command line interface for the Switch.
b Enter the following at the top-level menu:
system reset yes
This command restarts the Switch and module immediately.
To reset the configuration to its factory default values:
1 Enter in the Configuration Application Menu Display, as shown in
2
Figure 12.
2 Enter to reset the module to its factory default values.
y
Resetting the module to the factory defaults also removes any passwords
that have been set, and resets the SNMP community strings.

Resetting the Module to the Factory Default Values

command on the Switch.
143