Charging The Battery; Installing The Battery - Toro TimeCutter HD X4850 Operator's Manual

Figure 53
1. Battery cover
4. Disconnect the negative (black) ground cable
from the battery post
Note:
Retain all fasteners.
5. Slide the rubber cover up the positive (red)
cable.
6. Disconnect the positive (red) cable from the
battery post (Figure
Note:
Retain all fasteners.
7. Remove the battery hold-down
lift the battery from the battery tray.
Figure 54
1. Battery
2. Negative (–) battery post
3. Bolt, washer, and nut for
the negative (–) battery
post
4. Bolt, washer, and nut for
the positive (+) battery
post
2. Fasteners
(Figure 54).
54).
(Figure 54), and
5. Positive (+) battery post
6. Terminal boot
7. Battery hold-down

Charging the Battery

Service Interval: Before storage—Charge the battery
1. Remove the battery from the chassis; refer to
Removing the Battery (page
2. Charge the battery for a minimum of 1 hour at
6 to 10 A.
Note:
Do not overcharge the battery.
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
g190587
disconnect the charger leads from the battery
posts (Figure
1. Positive (+) battery post
2. Negative (–) battery post

Installing the Battery

1. Position the battery in the tray
2. Using the fasteners previously removed, install
the positive (red) battery cable to the positive
(+) battery terminal.
3. Using the fasteners previously removed, install
the negative battery cable to the negative (-)
battery terminal.
4. Slide the red terminal boot onto the positive
(red) battery post.
5. Secure the battery with the hold-down
54).
g188903
6. Install the battery cover by pushing down and
tightening the 2 fasteners clockwise
39
and disconnect the battery cables.
38).
55).
Figure 55
3. Red (+) charger lead
4. Black (–) charger lead
(Figure
g000538
54).
(Figure
(Figure 53).