Starting The Engine; Shutting Off The Engine - Toro TimeCutter HD X4850 Operator's Manual

Starting the Engine

Note:
A warm or hot engine may not require choking.
Important:
Do not engage the starter for more
than 5 seconds at a time. Engaging the starter
motor for more than 5 seconds can damage the
starter motor. If the engine fails to start, wait 10
seconds before operating the engine starter again.
Figure 20

Shutting Off the Engine

1. Disengage the blades by moving the
blade-control switch to the O
19).
2. Engage the parking brake; refer to
Parking Brake (page
3. Move the throttle control to the F
4. Turn the key to the O
the key.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the key and engage the
parking brake when leaving the machine
unattended.
Using the Motion-Control
Levers
g189354
1. Motion-control
lever—N
EUTRAL
position
2. Center, unlocked position
3. Forward
19
position
FF
17).
AST
position and remove
FF
c:\data\documentum\checkout\g004532
Figure 21
4. Backward
-
LOCK
5. Front of machine
(Figure
Engaging the
position.