Toro TimeCutter HD X4850 Operator's Manual page 9

Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in those conditions
on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine. If possible, keep the
cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units while operating on slopes can
cause the machine to become unstable.
1. Warning—read the Operator's Manual.
2. Ramp hazard—do not use dual ramps when loading onto a
trailer; use 1 ramp wide enough for the machine; use a ramp
with a slope less than 15°; back up the ramp when loading the
machine and drive forward off the ramp when unloading.
3. Thrown object hazard—keep bystanders a safe distance from
the machine, pick up debris before operating, and keep the
deflector shield down.
4. Bodily harm hazard—do not carry passengers; look behind
you when mowing in reverse.
1. Fast
2. Slow
3. Choke
133-9255
5. Tipping hazard—do not use on slopes near open water; do
not use on slopes greater than 15°.
6. Cutting and pinch hazard—keep away from moving parts;
keep all guards and shields in place.
7. Warning—before performing maintenance, read the
Operator's Manual; engage the parking brake, remove the
key, and disconnect the spark plug.
133-9263
4. PTO disengage
5. PTO engage
9
decal133-9255
decal133-9263