Toro TimeCutter HD X4850 Operator's Manual page 24

9. Locate the cutoff baffle in the loose parts bag
and remove the fasteners at the rear holes of
the discharge plate
1. Carriage bolts (existing)
2. Rear holes in the
discharge plate
10. Install the baffle at the side discharge opening
on the mower deck.
11. Use the fasteners removed to secure the cutoff
baffle to the deck.
12. Install the mower deck; refer to
Mower Deck (page
Machines with 137 cm (54-inch)
Mower Decks
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the mower deck; refer to
Mower Deck (page
4. Remove the 3 locknuts (5/16 inch) secured to
the welded posts of the left baffle on the top of
the mower deck at the center, left of center, and
left positions (Figure
(Figure 31).
Figure 31
3. Cutoff baffle (loose)
4. Locknuts (existing)
Installing the
47).
Removing the
46).
32).
1. Locknut (5/16 inch)
2. Carriage bolt (5/16 x 3/4
inch)
5. Remove the carriage bolt and locknut on the
side wall of the mower deck securing the left
g190734
baffle to the deck
6. Remove the left baffle from the mower deck
(Figure 32).
7. Locate the 2 bolts in loose parts and use the
existing locknuts and install these fasteners into
the holes shown in
to prevent flying debris.
Note:
Install the bolt upward, through the
underside of the deck and use an existing
locknut to secure from the topside.
8. Remove the carriage bolt (5/16 x 3/4 inch) and
locknut (5/16 inch) on the rear wall of the mower
deck securing the baffle to the deck
24
Figure 32
3. Left baffle
4. Install the fasteners here.
(Figure 32).
Figure 32 on the mower deck
(Figure
g011149
33).