Page 1
Installation and Operating Manual ebios fire - Solitär GB 1...
Page 2
FOREWORD / QUALITY PHILOSOPHY You have chosen a SPARTHERM ebios-fire. Thank you for your confidence in our technology. In a world characterised by excess and mass production, the good name of our firm is inextricably linked to the credo of our owner, Gerhard Manfred Rokossa: „High technical quality combined with modern design and on-site customer...
Page 3
5.4 Appearance of flames changes 2.4 Installation location 5.5 Spilt ethanol ignites 2.5 Assembly / installation 2.5.1 Assembly / Installation – Models Quadra and Elipse 6. General warranty conditions 2.6 Fire protection 6.1. Scope of application 2.7 Combustion air supply 6.2.
IMPORTANT NOTE 1. GENERAL INFORMATION Pursuant to the German Equipment and Product Safety Act (GPSG) and Small children, the old or infirm: as with all open flames it is sensible to fit a our statutory duty to draw attention to the heat generated by this product, protective device for these groups of people - Burn risk! Never allow these please note the following: people near the burning or just extinguished ebios-fire unsupervised! The...
The ebios-fire is not a heater – it is a decorative fire. Bio-ethanol is a hazardous material and may only be stored in quantities allowed by the regulations: Storage in basement: max. 20 litres Storage in living area: max. 5 litres 1.1 SCOPE OF DELIVERY ebios-fire including the following: •...
Air exchange at air exchange rate: ** Corresponding room size at room height 2.5m ** 34m2 67m2 167m2 The following are rough air exchange estimates Model Elipse Air exchange [1/h] Note Placement Floor 0…0,5 Windows and doors closed Number of burners 0,3…1,5...
Page 7
Weight kg 19,5 Model Elipse with base Model Elipse Wall Placement Floor Placement Wall Number of burners Number of burners Width mm Width mm Depth mm 235 (without base) Depth mm Height mm 520 (with base) Height mm Weight kg...
Page 8
Model Quadra Model Quadra Floor Wall Placement Placement Number of burners Number of burners Width mm Width mm Depth mm Depth mm Height mm Height mm Weight kg Weight kg GB 8...
Page 9
Model Quadra-Elipse Model Quadra-Elipse with base Wall Floor Placement Placement Number of burners Number of burners Width mm 1090 Width mm 1085 Depth mm Depth mm 300 (without base) Height mm Height mm 520 (with base) Weight kg Weight kg...
Page 10
Model Elipse-Case Model Elipse Z Floor Floor Placement Placement Number of burners Number of burners Width mm Width mm Depth mm Depth mm Height mm Height mm Weight kg 41,5 Weight kg 44,5 GB 10...
2.2 BURNER MAT CERAMAT FN • There must be no fuel in the fire tray during transport. The included CERAMAT FN (black) burner mat should only be handled with Damage in transit - Please contact your supplier without delay. Protect the gloves to prevent possible skin irritation.
2.5 ASSEMBLY / INSTALLATION 2.5.1 ASSEMBLY / INSTALLATION – MODELS QUADRA AND ELIPSE Whether free-standing or wall-mounted, the ebios-fire unit must be aligned horizontally and secured so that it cannot tip. The wall-mounted model Close the furniture housing cover. Please ensure correct positioning so that should be attached to the wall and the free-standing model should be fas- there is a uniform (depending on the model see Fig.
2.7 COMBUSTION AIR SUPPLY Housing cover Burner Your ebios-fire draws its combustion air from the room in which it is installed (dependent on indoor air). It must be ensured that there is a suf- ficient supply of fresh air to the room in which the fire is installed. It is Fig.
Page 14
DANGER TO LIFE • Never leave the fire unattended whilst it is alight! • With all models (Elipse, Quadra and Quadra Elipse) it must be ensured that the housing covers are closed and that the protective panes are inserted.
3.2 FIRE PROTECTION prevent it from being ignited unintentionally or by unauthorised persons and to also stop the fuel from evaporating. Please note: In the radiation area Fig. 5 (in the area of the flames/furniture) the flammable components and furniture within 1000 mm upwards and 300 Please note that ethanol is used exclusively for combustion and it not suit- mm to the sides must be fitted with ventilated radiation protection on both able for consumption.
3.4.1 STARTUP OF THE MODELS ELIPSE, QUADRA 8. The fill level indicator shows the maximum permitted fill level. The AND QUADRA-ELIPSE maximum fill level is reached when the bioethanol runs out of the slit (see arrow) into the reflector curve.
Page 17
11. Close the housing cover of the fireplace furniture, ensure that the cover 16. Ignite the fire on the burner mat and step back from the flames. It may does not project into the flames but remains a uniform distance from the take a few minutes until uniform flames appear.
3.5 REFILLING THE BURNER 4. Check the tank content. 5. Make sure that the cover plate is placed on the burner and covers the The burner must NOT be filled when warm or alight and must NOT be filled burner mat. via the burner channel! DANGER TO LIFE! 6.
5. MAINTENANCE/TROUBLESHOOTING 3.6 TAKING OUT OF OPERATION SAFELY If you wish to take the burner out of operation prematurely, place the cover • The wick and burner mat must be visually inspected at regular intervals. on the burner with the aid of the grip stick. The material can be easily damaged.
Spartherm Feuerungstechnik GmbH grants a 24-month warranty on ebios- fire devices (Solitaire and inserts) Spartherm Feuerungstechnik GmbH grants a 6-month warranty on wearing parts in the fire area, e.g., wicks, burner mats, seals and glass ceramic.
Damages and claims for compensation which are not the result of delivery FURNITURE/FIREPLACE WITH THE of a defective device from Spartherm Feuerungstechnik GmbH are excluded and are not part of this warranty promise. The above shall not include claims SOLITAIRE SERIES made in respect of statutory legal requirements.