ProForm Crosswalk PFTL56007.0 User Manual page 8

5. Attach two Base Pads (82) to the Base (108)
with two 1" Tek Screws (83) as shown.
Insert the other Extension Leg (89) into the
Base (108) as shown. Hold two Extension Leg
Nuts (67) in the bottom of the Extension Leg.
Next, insert two Extension Leg Bolts (65) into
the top of the Extension Leg, and firmly tighten
the Extension Leg Bolts into the Extension Leg
Nuts.
With the help of a second person, carefully tip
the treadmill so that all four Base Pads (82) are
flat on the floor.
6. Have the second person hold the console as-
sembly near the Right Upright (107) as shown.
Look under the console assembly and locate
the console wire.
Remove the tie from the Wire Harness (77).
Connect the Wire Harness to the Console Wire
(66). See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON.
7. Insert the Wire Harness (77) and the Console
Wire (66) into the Right Upright (107).
Set the console assembly on the Left Upright
(84) and the Right Upright (107). Be careful to
avoid pinching the wires. While a second per-
son holds the console assembly, attach it to the
Uprights with four Console Bolts (64) and four
Star Washers (8) as shown; start all four
Console Bolts and then firmly tighten them.
Plug in the power cord as described on page
11, and turn on the power as described on page
13. Note: The treadmill may automatically rise to
the maximum incline level and then return to the
minimum level. Adjust the incline to the lowest
inline level as described in step 4 on page 14.
5
108
82
83
67
6
Console
Assembly
66
Tie
77
7
Console
Assembly
77, 66
8
64
107
8
65
82
89
66
77
107
8
64
84