Selecting A Magazine - Siemens SINUMERIK 840D sl Operating Manual

Unloading tools
10.5.6

Selecting a magazine

You can directly select the buffer memory, the magazine, or the NC memory.
Procedure
Hiding magazines
Universal
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
1. Place the cursor on the tool that you would like to unload from the mag-
azine and press the "Unload" softkey.
2. Select the required load point in the "Loading Point Selection" window.
3. Confirm your selection with "OK".
- OR -
Undo your selection with "Cancel".
1. The tool list is opened.
2. Press the "Magazine selection" softkey.
If there is only one magazine, you will move from one area to the next
(i.e. from the buffer memory to the magazine, from the magazine to the
NC memory, and from the NC memory back to the buffer memory) each
time you press the softkey. The cursor is positioned at the beginning of
the magazine each time.
- OR -
If there is more than one magazine, the "Magazine Selection" window
opens. Position the cursor on the desired magazine in this window and
press the "Go to" softkey.
The cursor jumps directly to the beginning of the specified magazine.
Tool management
10.5 Tool list
225