Siemens SINUMERIK 840D sl Operating Manual page 217

Column heading
N
M1 - M4
Further parameters
If you have created unique cutting edge numbers, they will be displayed in the first column.
Column heading
D no.
SN
EC
You use the configuration file to specify the selection of parameters in the list.
References
Information about the configuration and setup of the tool list can be found in the following
references:
SINUMERIK Operate (IM9) / SINUMERIK 840D sl Commissioning Manual
Universal
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Meaning
Number of teeth for Type 100 - milling tool, Type 110 - ball end mill for
cylindrical die-sinking cutter, Type 111 - ball end mill or tapered die-
sinking cutter, Type 120 - end mill, Type 121 - end mill with corner round-
ing, Type 130 - angle head cutter, Type 131 - angle head cutter with cor-
ner rounding, Type 140 - facing tool, Type 150 - side mill, Type 155 -
bevel cutter, Type 156 - bevel cutter with corner rounding and Type 157 -
tapered die-sinking cutter.
Direction of spindle rotation
Spindle is not switched on
CW spindle rotation
CCW spindle rotation
Coolant 1 and 2 (e.g. internal and external cooling) can be switched on
and switched off.
The coolant infeed at the machine does not necessarily have to be set-up.
Other tool-specific functions such as additional coolant infeed, monitoring
functions for speed, tool breakage, etc.
Meaning
Unique cutting edge number
Cutting edge number
Setting-up offsets
Display of the available setup offsets
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Tool management
10.5 Tool list
217