Retard Roller Assy - Epson L1800 Service Manual

L1800
 Make sure to install the LD Roller with the triangular groove
marked inside as shown below.
Figure 3-93. Reinstalling the LD Roller
 Align the phases of the ASF Sensor Flag and LD Roller Shaft as
shown below.
Align the position for protrusion of LD Roller
Shaft with protrusion of ASF Sensor Flag.
ASF Sensor Flag
Figure 3-94. Reinstalling the ASF Sensor Flag
After replacing the following parts, be sure to apply G-26 and G-75
A D J U S T M E N T
R E Q U I R E D
grease to the area specified for each part.
 ASF Frame:See Figure 5-15 on page 140.
 LD Roller Shaft: See Figure 5-16 on page 140.

Hopper: See Figure 5-17 on page 140.
Disassembly And Assembly
LD Roller
Triangular groove
LD Roller Shaft
Disassembling the Printer Mechanism

3.4.8 Retard Roller Assy

When replacing the Retard Roller Assy, replace the LD Roller
C H E C K
P O I N T together with the Retard Roller Assy.
(p.74).)
1. Remove the ASF Assy. (p.71)
2. Release the Paper Back Lever Right from the two grooves of the ASF Assy.
3. Release the shaft end of the Paper Back Lever Right, and remove the Paper Back
Lever Right and the torsion spring from the ASF Assy.
Bottom side
Torsion spring
Paper Back Lever Right
Figure 3-95. Removing the Retard Roller Assy (1)
Revision A
(Refer to 3.4.7 LD Roller
Shaft end
Groove
76
Confidential