Table of Contents
Advertisement
CONTROL AND CONNECTIONS/DAY&NIGHT
I/O / ALARM OUT TERMINALS
1
UTP-
UTP+
(optional)
(optional)
1)
UTP Connections/Video output (optional)
●
1 PIN: UTP-
●
2 PIN: UTP+
2)
DAY&NIGHT I/O Terminals
To select Day/Night mode using external equipment, by connecting control lines
to the appropriate terminals.
●
DAY&NIGHT OUTPUT (4pin)
Is the camera function that can turn on an external IR LED Lamp by detecting the
sensitivity on the AGC level when the D&N mode is set "AUTO" on the OSD menu of the
camera
4
DAY&NIGHT OUTPUT
5
●
DAY&NIGHT EXTERNAL INPUT (3pin)
Is the camera function that can be switched to DAY Mode or NIGHT mode by receiving
the D&N on/off signal from external light sensor or IR LED LAMP. This needs the D&N
Mode to be set to "External" on the OSD menu of the camera to work
5
3
DAY&NIGHT INPUT
3)
ALARM OUT (6pin)
Motion detection signals are output through this port. Active state is configurable.
4)
POWER INPUT TERMINAL
CLASS 2
+ DC 12V -
~ AC 24V ~
AC 100-240V
5)
CAMERA CONTROL
●
7 PIN: RS 485+
●
8 PIN: RS 485-
2
3
4
D&N I/O
IN
OUT
COM
COM
●
This terminal accepts a DC12V or AC24V power
source from a DC12V or AC24V ac +/-10%
60/50Hz +/- 1Hz.
●
Use Certified/Listed Class 2 power supply only.
●
It is recommended to use the DC power supply that can
support inrush current over 0.75A
●
AC Power Cord - This power cord accepts a
100-240V ~ 50Hz +/- 1Hz
5
6
COM
ALARM
GND
OUT
●
5V/10mA : IR LED ON (NIGHT)
●
0V
Open contact: DAY
Close contact: NIGHT
13
7
RS-485
RS-485+(RX)
RS-485-(TX)
: IR LED OFF (DAY)
8
Advertisement
Table of Contents
