Ford 1997 Aerostar Workshop Manual page 23

1997 Aerostar/Ranger
8. Lower fuel tank.
9. Remove fuel supply hose at sender push connector. To disconnect push connect fittings, refer to
Push Connect Fittings
10. Remove fuel return hose at sender unit push connector. To disconnect push connect fittings, refer to
Push Connect Fittings
11. Disconnect sender and fuel pump electrical connector.
12. Remove fuel vapor hose from evaporative emission valve.
13. Lower fuel tank from vehicle.
14. For installation, follow removal procedures in reverse order. The fittings used on 7.9mm (5/16-inch)
nominal diameter nylon tubing use a hairpin clip. Clips should be replaced whenever a connector is
removed. Refer to Push Connect Fittings in this section. Tighten U-lock nuts securing front and rear
fuel tank support straps to 34-46 Nm (25-34 lb-ft). Tighten clamp securing fuel tank filler pipe to 3-4
Nm (27-35 lb-in).
Fuel Tank Installation, Ranger Regular Cab, Standard Tank
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVKA1016.HTM~gen~ref.HTM
in this section.
in this section.
tomsn048@gmail.com
Page 4 of 6
2011-04-29