Ford 1997 Aerostar Workshop Manual page 22

1997 Aerostar/Ranger
12 9092
13 N620480-S36
14 9A032
15 N802253-S36
16 9240
17 N801107-S36
18 9A307
19 9323
20 9B324
21 9H307
22 9417
A —
B —
C —
D —
E —
F —
Plastic Midship, Ranger
Removal and Installation
1. NOTE: Make sure fuel tank is properly supported during removal and installation procedures.
Drain fuel from fuel tank.
2. Loosen fill pipe clamp.
3. (4x4 only) Remove bolts securing skid plate assembly to frame (5005) and remove assembly from
vehicle.
4. Remove fuel tank filler pipe from vehicle.
5. Support fuel tank.
6. Remove bolts and nuts from rear fuel tank support strap and remove rear fuel tank support strap.
7. Remove bolt and nut from front fuel tank support strap and remove front fuel tank support strap.
file://C:\TSO\tsocache\VDTOM_5368\SVK~us~en~file=SVKA1016.HTM~gen~ref.HTM
Fuel Tank Support Strap
Nut
Fuel Tank Heat Shield
Bolt
Insulator, Fuel Tank
U-Nut
Fuel Tank Sending Unit Locking Retainer Ring
Tube Assembly, Fuel Tank to Filter
Tube Assembly, Fuel Rear
Fuel Pump and Sender Assembly
Fuel Pump Mounting Gasket
Tighten to 3.5-4.5 Nm
(31-39 Lb-In)
Tighten to 2-3 Nm
(18-25 Lb-In)
Tighten to 8-11 Nm
(6-8 Lb-Ft)
Tighten to 3.5-4.5 Nm
(31-39 Lb-In)
Tighten to 47-63 Nm
(35-46 Lb-Ft)
Tighten to 54-71 Nm
(40-52 Lb-Ft)
tomsn048@gmail.com
Page 3 of 6
2011-04-29