Any changes made to the series are automatically stored. Once you have completed editing the
series, press
to return the series list.
4) Add a new series
•
To add a new series press
•
Select which template the series will be based on (see 'Templates' described earlier in this
section for instructions on setting up a template):
•
Enter a relevant series name and type it at the top of the screen under 'Name'.
•
Then, design the new series by defining these elements:
-
Should it be a single or multiple measurements?
Note: if 'Single Shot' is activated some of the below options are disabled.
-
Should the pass/fail check be activated? If yes, remember to insert the desired
performance value(s) for background, legend, and/or contrast. Type '0' or leave the field
blank if a performance check for one of these is not needed.
-
How many measurements (of background and legend) should been taken? Use the
swipe up / down functionality to select the relevant number (0-10).
RetroSign GRX User Manual / December 2017
at the top of the screen.
29
DELTA