Assembly - ProForm CrossTrainer PFEX39930 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the crosstrainer in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. In addition to the included
allen wrenches, assembly requires a phillips screwdriver , an adjustable wrench
and a rubber mallet .
As you assemble the crosstrainer, use the drawings below to identify the small parts used in assembly. The
number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page
22. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-
assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
M6 Flat M10 Zinc Split M10 Black Nylon M10 Zinc Nylon
M8 Nylon
Washer (71)–1 Washer (85)–2 Locknut (63)–2 Locknut (66)–2
Locknut (61)–4
M4 x 22mm
1/2" Nylon M4 x 16mm M6 x 16mm M6 x 25.4mm Button
Screw (73)–6 Screw (91)–2
Locknut (52)–1 Screw (64)–5 Screw (79)–1
M8 x 14mm Button M8 x 39mm Button
M6 x 50mm Screw (69)–1
Bolt (76)–2
Screw (88)–1
M8 x 12mm Button M10 x 52mm Zinc Button
M10 x 45mm Button
Screw (94)–4 Bolt (68)–2
Screw (74)–2
M10 x 112mm Carriage Bolt (65)–2
1/2" x 70mm Button Bolt (51)–1
4