Table of Contents
Advertisement
Weighing Functions
n weight value, which is calculated by the SIWAREX FTA with a measurement rate
of 10 msec, e.g. at n=10, 10 values are taken to create the average value Every
10 msec, the oldest value is dropped and the newest value is taken into account
for the calculation.
5.2.7
DR3 - Scale Name
The name consists of maximum 10 characters and can be selected as you wish.
Note
The scale name can no longer be changed after the official calibration.
5.2.8
DR3 - Number of weight ranges
SIWAREX FTA can be defined as a scale with one, two or three different
measurement ranges. Depending on the construction type certification, the
numeral step can be defined separately for every range.
5.2.9
DR3 - Scale type
If the number of ranges is greater than one then the scale type can be defined as
a multi-range scale or a multi-resolution scale.
Information on the function of a multi-range- or multi-resolution-scale can be found
in EN 45 501.
Note
If only one range is defined then this entry is meaningless.
5.2.10 DR3 - Activate zero setting on start-up
The scale can be set to zero automatically by switching the supply voltage on (for
calibratable scales after waiting period after reboot). On calibratable scales, a
weight value of +/- 10% of the max. measurement range can be set to zero on
start-up.
!
Attention
In non-calibratable operation (no OIML restrictions), a full scale can also be set to
zero after activating this function. Limiting the effectiveness is possible by entering
the max. and min. weight however. See Max. Min. Weight for dss zero setting at
start-up.
5.2.11 DR3 - Activated zero setting at start-up, if scale is tared
The scale can be set to zero automatically by switching the supply voltage on. If
the above function (5.2.10) is activated, there is still the question of whether zero
setting at start-up should be run if the tare is unequal to zero.
5-50
SIWAREX FTA
Advertisement
Table of Contents
