Dr 30 - Awi Status Flags - Siemens SIWAREX FTA Device Manual

Weighing Functions
Bit No.
17 RS232-Print not possible
18 MMC inserted
19 MMC ready
20 MMC-trace ready
21 MMC-log ready
22 Trace active
23 Min. through-put 1 overshot
24 Min. through-put 2 overshot
25 Empty message
26 Calibration data protection
27 Starting up
28 MMC data ready S7
29 Digital LC active
30 Stand-alone operation
31 Operating error
Table 5-19 DR 30 - NAWI status bits

5.19.2 DR 30 - AWI status flags

Bit No.
0 Weighing steps
1
2
3
4
5
6
7
8 Post dosing active
9 Course signal
10 fine signal
11 Timer pre-dosing
Empty signal
12
13 Weighing stopped
14 Weighing stopped because
of check stop
15 Check stop follows
16 Last weighing procedure
aborted
17 Weighing blocked
18 TO2
19 TO1
20 Good
21 TU1
22 TU2
23 TOL bad
24 Standstill 2
25 Standstill 3
26 Check to follow
5-112
Name
The log cannot be printed.
The MMC is in position
The MMC is formatted and ready for recording
The MMC is ready for the trace function
The MMC is ready for logging
The trace function is activated
Through-put monitor 1 activated
Through-put monitor 2 activated
Scale in empty range
The switch for protecting the calibration data is switched on
Set during the warming up phase (duration 1 min, no
commands given, in Ascii weight DR 34 the FW-Version is
shown)
Preparing the MMC data with the default in DR 46 ended for
S7 interface DR 47
0 = Digital load cell recording not active
1 = Digi load cell recording is running
0 = SIMATIC operation activated
1 = Stand-alone operation activated
At least one operating error (fault) exists
Name
Current weighing control step
0 to 7
Post dosing is active
The coarse signal is switched on
The fine signal is switched on
The timer for pre-dosing is active
The empty signal is switched on
The weighing cycle has been stopped
The weighing cycle has been stopped because of the check
stop command
The weighing cycle will be stopped by a check stop
(is set with the check stop command and reset if the check
stop is achieved)
Last weighing procedure aborted with "Residual weighing"
or "Reset weighing control".
Set if the step-on to the next step in the weighing cycle is
blocked because of a missing step enable.
Net weight above the TO2 limit
Net weight above TO1
Net weight in tolerance TU1 to TO1
Net weight under TU1 but over TU2
Net weight under TU2
Net weight under TU2 or over TO2
Stand-still 2 exists
Stand-still 3 exists
A control weighing is run at the end of the cycle
Range of Values / Explanation
Range of Values / Explanation
Reference
Reference
SIWAREX FTA