Table 12: Is Battery Pack Replacement Procedure - Honeywell XYR 6000 User Manual

IS Battery Pack, 50047517-501
Step
1
WARNING
DO NOT DISASSEMBLE OR ASSEMBLE WHEN AN EXPLOSIVE ATMOSPHERE IS PRESENT
Loosen the M3 locking set screw on the battery end-cap (opposite end from display). See item 1 in
2
Figure 1. Unscrew and remove the end cap.
Using thumb and forefinger, squeeze the battery connector at top and bottom to disengage the
3
locking mechanism, then pull to disconnect. See item 2 in Figure 1.
Loosen the two battery holder retaining screws (closest to the batteries). See item 3 in Figure 1.
4
The screws are captive.
Pull the battery holder out of the transmitter.
5
Remove top of battery pack by using a #1 Philips or 1/8" slotted screwdriver for the screws identified
6
as #3 in Figure 8.
Remove the old batteries and dispose of them promptly according to local regulations of the battery
7
manufacturer's recommendations.
Install the batteries following the polarity as noted on the lid
8
Re-install top of the battery pack and tighten screws
9
Insert the Battery pack into the transmitter. Reattach the screws as indicated in Figure 8, item 3, to
10
0.4 to 0.6 N-M (3.5 – 5.3 Lb-in).
Reconnect the Battery Pack connector
Honeywell recommends lubricating the end cap with a silicone grease such as Dow Corning #55 or
equivalent before replacing the end cap
Screw the cap back on and tighten the M3 locking screw
11
Revision 1
January 2011

Table 12: IS Battery Pack replacement procedure

Figure 8: IS Battery Pack
User's Manual
Action
37