Advertisement
PROGRAMMING
Refer to the control panel's installation instructions for programming and
enrolling the 5800MINI.
1. Enter Programming mode at the control. Assign a
zone number to loop 1 and assign as Input Type 3
(Supervised RF).
2. To enroll the serial number, activate the
transmitter twice by moving the magnet close to
and away from the module.
Alternatively, enter the device serial number
manually when prompted.
BATTERY REPLACEMENT
1. Open the cover and remove the old battery.
2. Install a fresh battery with
Specifications section for compatible batteries.
3. Replace the cover.
SPECIFICATIONS
Dimensions:
Transmitter: 1" (25.4mm) x 2.2" (55.9mm) x 0.25"
Magnet:
Operating
32°F
(0°C) to
Conditions:
Relative Humidity 95%, (non-condensing); UL Tested at 85%
Magnet Gap:
1" (25.4mm) max.
Battery:
3VDC, 225mAh, Lithium Coin Cell;
FEDERAL COMMUNICATIONS COMMISSION STATEMENT
The user shall not make any changes or modifications to the equipment unless authorized by the Installation
Instructions or User Manual. Unauthorized changes or modifications could void the user's authority to
operate the equipment
FCC/IC STATEMENT
This device complies with Part 15 of the FCC Rules,
and RSS-210 of Industry Canada (IC). Operation is
subject to the following two conditions: (1) This
device may not cause harmful interference (2) This
device must accept any interference received,
including interference that may cause undesired
operation.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS
DEVICE IS USED, FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
SUPPORT & WARRANTY
For the latest documentation and online
support information, please go to:
https://mywebtech.honeywell.com/
For the latest warranty information, please go to:
www.honeywell.com/security/hsc/resources/wa.
For patent information:
www.honeywell.com/patents
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Copyright 2016 Honeywell International Inc.
www.honeywell.com/security
+
side UP. See
0.25"
(6.35mm)
x 0.25"
(6.35mm)
120°F
(50°C)
Panasonic CR2032,
Cet appareil est conforme à la partie 15 des règles de
la FCC & de RSS-210 des Industries Canada. Son
fonctionnement est soumis aux conditions suivantes:
(1) Cet appareil ne doit pas causer d' interférences
nuisibles. (2) Cet appareil doit accepter toute
interférence reçue y compris les interférences causant
une réception indésirable.
MyWebTech
Ê800-22088SŠ
(6.4mm)
x 1" (25.4mm)
Warranty
Patents
800-22088 6/16 Rev B
Advertisement
