Port Gigabit Ethernet Spa Connectors - Cisco ASR-1000-SIP10 Hardware Installation Manual

Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers Shared Port Adapters
Table 3-20
Table 3-20
LED Label
A/L
STATUS

10-Port Gigabit Ethernet SPA Connectors

The 10-Port Gigabit Ethernet SPA has ten electrical connectors that support SFP modules. Each port can
send and receive traffic using cabling appropriate for the SFP module inserted.
SFP Module Connections
The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit
Ethernet optical slots on the 10-Port Gigabit Ethernet SPA, linking the port with a 1000BASE-X
fiber-optic network.
The 10-Port Gigabit Ethernet SPA will only accept the SFP modules listed as supported in this
Note
document. An SFP module check is run every time an SFP is inserted into the 10-Port Gigabit Ethernet
SPA and only SFP modules that pass this check will be usable by the 10-Port Gigabit Ethernet SPA.
SFP modules exist for technologies other than Gigabit Ethernet and for products other than the 10-Port
Gigabit Ethernet SPA. However, the information in this document pertains only to SFP modules that
plug into the 10-Port Gigabit Ethernet SPA ports.
See the
SFP module options, module specifications, and cabling specifications.
For CWDM and DWDM SFP module specifications, see the
Gigabit Ethernet SPAs" section on page
SFP Module and Cabling Specifications for Gigabit Ethernet SPAs
The following sections describe SFP module specifications and cabling information for the Gigabit
Ethernet SPAs:
•
•
OL-14126-03
describes the 10-Port Gigabit Ethernet SPA LEDs.
10-Port Gigabit Ethernet SPA LEDs
Color
Off
Green
Amber
Off
Green
Amber
"SFP Module and Cabling Specifications for Gigabit Ethernet SPAs" section on page 3-25
SFP Module Specifications, page 3-26
SFP Module Cabling and Connection Equipment, page 3-28
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
State Meaning
Off Port is not enabled.
On Port is enabled and the link is up.
On Port is enabled and the link is down.
Off SPA power is off.
On SPA is ready and operational.
On SPA power is on and good, and the SPA is being
configured.
3-29.
10-Port Gigabit Ethernet SPA Overview
"CWDM and DWDM SFP Modules for the
for
3-25