Port Gigabit Ethernet Spa Overview - Cisco ASR-1000-SIP10 Hardware Installation Manual

Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers Shared Port Adapters

8-Port Gigabit Ethernet SPA Overview

The following sections describe the 8-port Gigabit Ethernet SPA:
•
•
8-Port Gigabit Ethernet SPA LEDs
The 8-Port Gigabit Ethernet SPA has two types of LEDs: an A/L LED for each port on the SPA, and one
STATUS LED, as shown in
Figure 3-20
1
Table 3-19
Table 3-19
LED Label
A/L
STATUS
8-Port Gigabit Ethernet SPA Connectors
The 8-Port Gigabit Ethernet SPA has eight individual fiber-optic receivers that support SFP modules.
Each port can send and receive traffic using the optical fiber connections.
SFP Module Connections
The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit
Ethernet ports on the 8-Port Gigabit Ethernet SPA, linking the port with a fiber-optic network.
OL-14126-03
8-Port Gigabit Ethernet SPA LEDs, page 3-23
8-Port Gigabit Ethernet SPA Connectors, page 3-23
Figure
8-Port Gigabit Ethernet SPA Faceplate
1
A/L (Active/Link) LED
describes the 8-Port Gigabit Ethernet SPA LEDs.
8-Port Gigabit Ethernet SPA LEDs
Color
Off
Green
Amber
Off
Green
Amber
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
3-20.
STATUS LED
2
State Meaning
Off Port is not enabled.
On Port is enabled and the link is up.
On Port is enabled and the link is down.
Off SPA power is off.
On SPA is ready and operational.
On SPA power is on and good, and the SPA is being
configured.
8-Port Gigabit Ethernet SPA Overview
2
3-23