Installing A Spa In A Sip - Cisco ASR-1000-SIP10 Hardware Installation Manual

Chapter 6 Installing and Removing a Shared Port Adapter
Figure 6-2

Installing a SPA in a SIP

To install a SPA in a SIP, refer to
To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are
Step 1
at the top left and top right of the SPA slot and are recessed about an inch.
Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface
Step 2
connector. When fully seated, the SPA might be slightly behind the SIP faceplate.
After the SPA is properly seated, fasten the SPA in place with the captive installation screws on either
Step 3
side of the SPA.
Removing a SPA from a SIP
To remove a SPA from a SIP, refer to
If attached, remove any cables from the SPA.
Step 1
To remove the SPA from the SIP, unfasten the captive installation screws on either side of the SPA.
Step 2
OL-14126-03
SPA Installation and Removal
AS R1 000 -SI
P1 0
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
PW R STA TUS
AS R1 000 -SI
P1 0
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
PW R STA TUS
SPA -4X OC
3-P OS
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
Figure 6-2 and do the following:
Figure 6-2 and do the following:
SPA Installation and Removal
6-3