Table of Contents
Advertisement
To adjust V-belt tension:
1.
Loosen the motor mount bolt.
2.
Shift the motor up or down to increase or
decrease the V-belt tension. Tighten the
motor mount bolt.
3.
Check the V-belt tension again. Ensure that
the motor pulley and arbor pulley are lined
up.
To replace the V-belts:
1.
Remove the blade.
2.
Adjust the arbor so it is up all the way and in
the 90° position.
3.
Place a board under the motor and loosen
the motor mount bolt. Slowly lower the arbor
until the motor rests on the board, allowing
the belts to be loose on the pulleys.
4.
Pull off the old V-belts and replace them with
new ones. Have the number from the belt
ready when calling the service department
for replacements.
5.
Raise the arbor and remove the board to
adjust the V-belt tension.
6.
Tighten the motor mount bolt.
-36-
Keep clothing rolled
up and out of the way
of machinery and keep
hair pulled back.
Wear safety glasses dur-
ing the entire mainte-
nance process. Failure
to comply may result in
serious personal injury.
Lubrication
Lubricate the areas indicated below every 12
months.
1.
Blade angling trunnions. These should be
lubricated with 6 or 7 drops of light machine
oil.
2.
Blade height trunnion. This should also be
lubricated with 6 or 7 drops of light machine
oil.
3.
The two (2) worm gears should be lubri-
cated with an automotive wheel bearing
grease.
These points can be reached by removing the
table. Check all adjustments when finished lubri-
cating.
G1023S/G1023S110 Heavy-Duty 10'' Table Saw
Advertisement
Table of Contents
