Printer Reset Conditions - Printek FormsMaster 8000se Series Programmer's Manual

PRINTER RESET CONDITIONS

The following list describes what conditions are assumed whenever the printer is powered on, the SETUP
mode is exited, or a reset escape sequence is received when the printer is operating in an emulation mode
which supports such a sequence.
This list includes all variables which may be modified by the user for all emulations even though some
emulations cannot modify all the variables shown. Refer to the appropriate chapter for the emulation being
used.
---------------
normal/slashed zero
unidiretional mode
text in an incomplete line
control of data bit 8
control character symbols
superscript/subscript
Variable Reset Condition
---------------
character pitch according to form setup
left margin according to form setup
right margin according to form setup
line pitch according to form setup
form length according to form setup
top margin according to form setup
bottom margin according to form setup
font according to form setup
impact mode according to form setup
language according to form setup
according to form setup
autocut mode according to form setup
according to form setup
top of form set to current position
discarded
input buffer cleared (unless reset from host)
accepted as received
according to interface setup
italics off
double high off
compressed off
double strike off
double wide off
elite off
emphasized off
off
underline off
horizontal tabs every eigth column
vertical tabs cleared
157