Emulations - Printek FormsMaster 8000se Series Programmer's Manual

Escape Sequence:
Hexadecimal:
Automatic Line Feed
Selects automatic line feed mode for n=1, or cancels for n=0. Automatic line feed mode causes the printer
to automatically perform a line feed (LF) for each carriage return (CR) it receives. Overrides the "Auto LF"
value in the interface setup menu.
Example: The following escape sequence will select automatic line feed mode.
Escape Sequence:
Hexadecimal:

Emulations

Select Software Interface n
Selects the software interface n according to the table below.
n
0
1
2
3
4
5
6
7
;
<
=
?
@
Overrides the "Emulation" value in the interface setup menu.
A numeric value for n may be specified in two different ways, with equivalent results: a single byte with a
value of 00 to 07 hex, or a single printable ASCII character "0" to "7" (30 to 37 hex).
If more than one emulation has been selected, ESC ESC ? will return to the previously selected emulation.
This is particularly useful when the previous emulation is unknown. Please beware that the memory (stack) is
only one level deep.
ESC ESC @ will return to the default emulation, as specified by the "Emulation" value in the interface setup
menu.
60
ESC U 1
1B 55 31
ESC 5 1
1B 35 31
Software Interface
Test (reserved for factory use)
ANSI X3.64 Emulation
Epson FX Emulation
Bar Code Mode (optional)
IBM Proprinter Emulation
DEC LA120/210 Emulation
TTY Emulation
Printek Emulation
Remote Setup Mode
Genicom 3840
Genicom 3410
Previously Selected Emulation
Default Emulation
IBM Proprinter Emulation
ESC 5 n
ESC ESC n