Emulations - Printek FormsMaster 8000se Series Programmer's Manual

Example: The following escape sequence will load form 2.
Escape Sequence:
Hexadecimal:

Emulations

Select Software Interface n
Selects the software interface n according to the table below.
n
0
1
2
3
4
5
6
7
;
<
=
?
@
Overrides the "Emulation" value in the interface setup menu.
A numeric value for n may be specified in two different ways, with equivalent results: a single byte with a
value of 00 to 07 hex, or a single printable ASCII character "0" to "7" (30 to 37 hex).
If more than one emulation has been selected, ESC ESC ? will return to the previously selected emulation.
This is particularly useful when the previous emulation is unknown. Please beware that the memory (stack) is
only one level deep.
ESC ESC @ will return to the default emulation, as specified by the "Emulation" value in the interface setup
menu.
This chapter describes Epson FX emulation. If a different interface is selected, the control codes and escape
sequences described in this chapter will no longer be applicable.
Example: The following escape sequences will select Printek emulation, load form one, and then return to the
previous emulation.
Escape Sequence:
Hexadecimal:
ESC EM 2
1B 19 32
Software Interface
Test (reserved for factory use)
ANSI X3.64 Emulation
Epson FX Emulation
Bar Code Mode (optional)
IBM Proprinter Emulation
DEC LA120/210 Emulation
TTY Emulation
Printek Emulation
Remote Setup Mode
Genicom 3840
Genicom 3410
Previously Selected Emulation
Default Emulation
ESC ESC 7
1B 1B 07
ESC L 1 ESC
1B 4C 01 1B
ANSI X3.64 Emulation
ESC ESC n
ESC ?
1B 3F
41