Line Pitch - Printek FormsPro 4300 Owner's Manual

Select Print Mode
Selects print mode n according to the following chart. Overrides the "Font:" value in
the "Setup: FORM" menu.
n
0
1
2
3
Example: The following escape sequence will select the IBM Proprinter letter quality
font.
Escape Sequence:
Hexadecimal:

Line Pitch

Select 8 LPI
Sets the line spacing to 1/8 of an inch per line (8 lpi). Overrides the "LPI:" value in
the "Setup: FORM" menu.
Escape Sequence:
Hexadecimal:
Set Line Spacing to 7/72"
Sets the line spacing to 7/72 of an inch per line. Since the distance between print
head wires is 1/72 of an inch, this is equivalent to setting seven wire spacing. This is
not particularly useful for text, but may be useful for graphics if 7-bit graphics data is
being sent. Overrides the "LPI:" value in the "Setup: FORM" menu.
Escape Sequence:
Hexadecimal:
Start Line Spacing
Sets the line spacing to the value selected by ESC A n. Overrides the "LPI:" value in
the "Setup: FORM" menu.
Escape Sequence:
Hexadecimal:
Print Mode
Draft
Draft 12 cpi
Letter Quality
Letter Quality
ESC I 3
1B 49 03
ESC 0
1B 30
ESC 1
1B 31
ESC 2
1B 32
IBM Proprinter Emulation
ESC I n
ESC 0
ESC 1
ESC 2
Page 4-9