Printek FormsPro 4300 Owner's Manual page 130

Printek Emulation
AutoCut
Selects Auto Cut On for n=1, or Auto Cut Off for n=0 for the currently selected form
if the optional Printek FormsCutter is installed. When Auto Cut is turned on, the
FormsCutter will automatically cut off each form as it is ejected from the printer.
Example: The following escape sequence will select Auto Cut = On.
Escape Sequence:
Hexadecimal:
Cut Form
Ejects the current form and cuts it off if the optional Printek FormsCutter is installed.
Escape Sequence:
Hexadecimal:
Reset
Deletes all data on the current line and initializes the printer to the default settings for
the current form.
Restores the default horizontal tab stops. Default tab stops are set at every eighth
column, i.e. column 8, 16, 24, 32, 40, etc.
Resets top of form to the current position, so it is wise to be at top of form before
performing this reset. Issuing a form feed will guarantee this.
See the appendix on Printer Reset Conditions for more information.
Escape Sequence:
Hexadecimal:
Page 7-18
ESC B 1
1B 42 31
ESC C
1B 43
ESC @
1B 40
ESC B n
ESC C
ESC @