Emulations - Printek FormsPro 4300 Owner's Manual

Emulations

Select Software Interface n
Selects the software interface n according to the table below.
n
0
1
2
3
4
5
6
7
?
@
Overrides the "Mode:" value in the "Setup: INTERFACE" menu.
BarberPole" and "Mode: Hex Dump" cannot be overridden.
A numeric value for n may be specified in two different ways, with equivalent results:
a single byte with a value of 00 to 07 hex, or a single printable ASCII character "0" to
"7" (30 to 37 hex).
If more than one emulation has been selected, ESC ESC ? will return to the
previously selected emulation.
emulation is unknown. Please beware that the memory (stack) is only one level deep.
ESC ESC @ will return to the default emulation, as specified by the "Mode:" value in
the "Setup: INTERFACE" menu.
This chapter describes Epson FX emulation. If a different interface is selected, the
control codes and escape sequences described in this chapter will no longer be
applicable.
Example: The following escape sequences will select Printek emulation, load form
one, and then return to the previous emulation.
Escape Sequence:
Hexadecimal:
Software Interface
Test (reserved for factory use)
ANSI X3.64 Emulation
Epson FX Emulation
Bar Code Mode (optional)
IBM Proprinter Emulation
DEC LA120 Emulation
TTY Emulation
Printek Emulation
Previously Selected Emulation
Default Emulation
This is particularly useful when the previous
ESC ESC 7
1B 1B 07
Epson FX Emulation
ESC L 1 ESC ESC
1B 4C 01 1B
ESC ESC n
"Mode:
?
1B 3F
Page 3-29