Table of Contents
Advertisement
Operating Instructions
6. O
PERATION
This chapter describes how to use the laminator to:
•
Operate the machine
•
Load films (web the machine)
•
Laminate items
•
Mount items
G
O
ENERAL
PERATION
These instructions assume that the films have been
loaded. For information about loading films, see the
Loading Film section in this chapter.
Speed
adjustment
min.
RUN
LED
STOP
REVERSE
Fig. 6-1. Control Panel.
To run the laminator:
1.
Turn the laminator On (I) with the power switch
located at the back of the machine.
WARNING: Make sure the safety shield and
feed tray are in their proper positions. Your fingers
and hands could be trapped and crushed in the
rollers. Clothing, jewelry, and long hair could be
caught in the rollers and pull you into them.
max.
RUN
button
STOP
button
REVERSE
button
2.
Set the roller pressure handle for the thickness of
the item that is to be laminated or mounted.
Fig. 6-2. Roller Pressure Handle.
3.
Set the desired speed on the control panel.
4.
Press the RUN button.
The rollers will begin to turn.
5.
Position the item(s) to be laminated or mounted
on the feed table.
6.
Push the item(s) squarely into the roller nip point
(where the two rollers meet). Additional items
can be laminated or mounted without stopping
and starting the machine.
7.
Press the STOP button to stop the laminator
when all of the items have completely exited the
rear of the machine.
27C
Page 6-1
Advertisement
Table of Contents
