Table of Contents
Advertisement
Operating Instructions
4. I
NSTALLATION
This chapter describes how to install the machine.
There are no operator serviceable parts to the
machine other than periodic cleaning. Refer to the
Operator Maintenance chapter.
WARNING: Do not attempt to service or repair
the laminator. Failure to observe this warning could
result severe personal injury or death.
Disconnect the plug from the receptacle and contact
your dealer/distributor when one or more of the
following has occurred.
•
The power supply cord or attachment plug is
damaged.
•
Liquid has been spilled into the laminator.
•
The laminator is malfunctioning after being
mishandled.
•
The laminator does not operate as described
in these instructions.
P
I
RIOR TO
NSTALLATION
Inspect the package for damage. Shipping damage
should be brought to the immediate attention of the
delivering carrier.
I
NSTALLATION
To set up the laminator for the first time:
1.
Place the laminator on a stable flat surface
capable of supporting the weight of the machine
and any materials. The surface should be at least
30 inches (0.76 m) high to assure comfortable
positioning during operation. All four rubber
support feet should be positioned completely on
the supporting surface. The supporting surface
may also be large enough to hold the material to
be laminated.
2.
The laminator should be located so that exiting
film drops freely to the floor or to a table that
is lower than the exit point of the laminator.
Accumulation of laminate immediately behind the
laminator as it exits the equipment may cause
the film to wrap around the rollers, jamming the
machine.
3.
Avoid locating the laminator near sources of heat
or cold. The laminator should not be in the direct
path of forced heated or cooled air.
4.
Connect the attachment plug provided with the
laminator to a suitably grounded outlet only.
27C
Page 4-1
Advertisement
Table of Contents
