Release Liner Take-Up - GBC 27C Installation & Operation Manual

Operating Instructions
5. F
EATURE GUIDE
This chapter helps you identify the main components of the laminator.
Pressure roller
Safety shield
Feed table
Feed table
interlock latch
(under table)
T F S
OP ILM UPPLY
Holds the film supply on the laminator.
R L T
ELEASE INER
Rewinds the release liner of pressure sensitive films.
I B
DLER AR
(Not shown.) The idler bar directs the film to the
roller.
P R
RESSURE OLLERS
Two pressure rollers apply pressure to the film and
the print being laminated or mounted. They pull the
print and films into the laminator.
Fig. 5-1. 27C Laminator Identification.
S
HAFT
-
AKE UP

Release liner take-up

N P
IP OINT
(Not shown.) The point at which the top and bottom
rollers come into contact and the point at which the
items for lamination are introduced into the laminator.
S S
AFETY HIELD
The safety shield prevents entanglement,
entrapment, and inadvertent contact with the rollers.
When the safety shield is removed, the laminator
runs at 3 fpm (0.9 m) when you press the RUN
button. The safety shield is removed only when you
load films.
WARNING: Keep your fingers and hands away
from the nip point. Failure to observe this warning
could result in severe personal injury.
27C
Top film supply shaft
Roller pressure
handle
Control panel
Bottom supply shaft
Page 5-1