Cleaning The Rollers - GBC Arctic Titan 165 Manual

WARNING: Do not apply any cleaning fluids or solvents to the rollers. Some
solvents and fluids may damage the rollers.
WARNING: Never clean rollers with sharp or pointed objects
CAUTION: Hardened adhesive deposits on the rollers can cause damage to the
rollers. Rotate the rollers at the lowest speed setting on the control panel.
1. Remove the film from the laminator following the procedure outlined in steps 1 through 7
of the section FILM LOADING AND THREADING, Using a Film Threading Card.
2. Rub the top and bottom rollers with a 3M™ Scotchbrite™ pad.
WARNING: DO NOT USE METAL SCOURING PADS!
3. Install the feed table safety shield.
4. Press RUN to rotate the rollers to an unclean portion. Press STOP. Continue this
process until the complete surfaces of both rollers are clean.
5. Follow the procedure in section FILM LOADING AND THREAD, Method Using Film
Threading Card to reload the laminator.
Page 18
Arctic Titan 165 Operation and Maintenance Manual

Cleaning the Rollers

© GBC Films Group October 2000