Table of Contents
Advertisement
62FM L
AMINATOR
A
PPLICATIONS
T
P
-
IPS FOR
RE
COATING
•
Load the laminator as shown.
Trailer board
Board
Fig. 6-19. Pre-coating Boards With Mount Adhesive.
•
Remove the chill idler.
•
Set the roller pressure handle to the correct
thickness.
•
The width of the roll should not exceed the
width of the board by more than ½ in. (1.3
cm).
•
Use a leader board to start the run and a
trailer board to finish the run.
•
Using the pull rollers will allow you to leave
gaps between boards.
•
If not using the pull rollers, have the boards
nearby to butt end to end during feeding.
10
B
OARDS
Mount adhesive
Leader board
T
U
IPS FOR
SING THE
If the front rollers are heated, you may perform
certain applications from the rear operating position
of the laminator. You may perform mounting
applications, pre-coating applications, and single
side applications from the rear of the machine.
PSA film
Fig. 6-20. Running From the Rear.
•
Remove the chill idler if using boards.
•
Ensure the safety shield is located in the
rear position and latched or use the foot
switch for slow speed operation.
•
Ensure the REAR CONTROLS have been
enabled.
•
Use the foot switch to run the laminator.
Operating Instructions
R
R
EAR
OLLERS
Release liner
Mounting film
Advertisement
Table of Contents
