GBC 62FM Installation & Operation Manual page 36

Operating Instructions
7. O
PERATOR
M
AINTAINING THE
The only maintenance required by the operator
is to periodically clean the rollers. The following
procedure will help keep them free of dirt and
adhesive, which has been deposited along the edge
of the laminating film. Proper alignment of the rolls of
film reduces the amount of adhesive on the rollers.
Perform only the routine maintenance procedures
referred to in these instructions.
WARNING: Do not attempt to service or
repair the laminator. Failure to observe this warning
could result severe personal injury or death or
damage the machine.
C R
LEANING THE OLLERS
Keeping the rollers clean ensures that your finished
items will not be damaged by dirt and adhesives.
You will need a 3M™ Scotch-Brite™ pad and a clean
rag moistened with water and dish soap.
•
Never clean rollers with abrasive, sharp, or
pointed objects.
• Do not use any other cleaning agents other
than those listed above.
•
Accumulated adhesive deposits on the rollers
can cause damage to the rollers. Rotate the
rollers at the lowest speed setting on the
control panel.
WARNING: Hot surfaces and pinch points.
Keep fingers and hands away from the heat pressure
and pull rollers when the laminator is running. Failure
to adhere to this warning could result in serious
personal injury.
1. Remove the safety shield and feed table.
2. Remove the film from the laminator.
Refer to Loading Film in the Operation chapter.
3. Preheat the laminator until the READY indicator
appears
4. Gently rub the heat and pull rollers, and idlers
with a 3M Scotch-Brite pad.
DO NOT USE METAL SCOURING PADS! Do
not use any abrasives to clean the rollers.
M
AINTENANCE
62FM L
AMINATOR
5. Use the dampened rag to remove any dust, dirt,
and other foreign materials from the rollers.
6. Use the foot switch to rotate the rollers to an
unclean portion.
Keep your hands, fingers, and the rag away while
running the machine. Be sure to remove any
dust, dirt, and other foreign materials from the
rollers.
7. Install the feed table and safety shield.
62FM L
AMINATOR
7-1