Table of Contents
Advertisement
Operating Instructions
T
M
IPS FOR
OUNTING ON
B
OARDS
Print
Liner
Board
Fig. 6-21. Mounting a Print on a Board.
•
Load the laminator as illustrated as shown.
•
Heat at 125 °F (52 °C), may assist the process
and increase output quality.
•
Do not stop once you have started the
mounting process through the machine.
T
PSA E
IPS FOR
NCAPSULATION
Print
Fig. 6-22. PSA Encapsulation With Poly-in Film.
•
Load the laminator as shown.
•
Always use two rolls of the same width.
•
Use minimal brake tension to achieve flat
output.
P
-
RE
COATED
•
The separation of the laminate and the release
liner should be maintained close to the heat
rollers.
•
A little heat, 125 °F (52 °C), may help eliminate
silvering effects associated with PSA films.
•
Use of the chill idler may or may not help in
the output quality. Try both methods.
T
T
IPS FOR
HERMAL
Print
Fig. 6-23. Thermal Encapsulation With Poly-in Film.
•
Load the laminator as shown for poly-in film.
•
Always use two rolls of film the same width.
•
Use minimal brake tension to achieve flat
output.
•
Increase speed gradually to maintain the
activating temperature required for the
laminate you are using.
•
Length and width of image, ink coverage and
paper type may effect the temperature and
speed required.
62FM L
AMINATOR
E
NCAPSULATION
11
Advertisement
Table of Contents
