GBC 62FM Installation & Operation Manual page 25

62FM L
AMINATOR
5. Pull the top roll of film down under the idler bar
and allow to drape over the top heat roller.
6. Reference one of the loading bottom material
procedures.
B T
OTTOM HERMAL
This procedure describes how to load a roll of
thermal film using the lower unwind position for
encapsulation. At this point you should have an
upper roll of thermal film loaded onto the laminator.
Fig. 6-5. Loading Bottom Thermal Film.
1. Ensure no brake tension is applied to the film
shaft.
2. Guide the bottom film around the lower idler.
3. Adhere the film to the loaded upper roll of
thermal film by pulling the film up towards the
existing draped thermal film over the main
rollers.
NOTE: You may follow this procedure to load a roll of
kraft paper for single side lamination.
5. Reference Threading Card Procedure.
4
F
ILM
L A S
OADING CCU
This procedure describes how to load a roll of
AccuShield film and attach the liner to the take-up.
IMPORTANT: When starting to laminate, always
start the rollers BEFORE applying pressure to the
rollers to prevent AccuShield build up on the roller.
When stopping, release the pressure on the rollers
BEFORE stopping the motor.
Fig. 6-6. Configuration for AccuShield Film.
1. Pull the film down, thread it under the idler bar
and drape it over the top heat roller.
Fig. 6-7. AccuShield Draped Over the Top Heat Roller.
2. Press the straight edge of the threading card
into the film at the nip until the card and film is
slightly past the nip.
The threading card for webbing AccuShield
film can be any stiff print. The film should be
wrapped around the leading edge of the card.
Operating Instructions
F
HIELD ILM