Product Specifications; Pre-Operation; Before Starting Engine; Add Gasoline - McCulloch RVM110 Manual

For lawn mowers mcculloch m40-110 classic
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 25
Vertical Shaft, 4-Stroke, OHV, Gasoline-Powered Engine
Serial Number:
Date of Purchase:
• The model and serial numbers will be found on the rear of the engine housing.
Record both serial number and date of purchase in the space provided above.
Gasoline Capacity / Type:
Oil Capacity:
Oil Type (API SJ–SN):
Spark Plug:
Valve Clearance (cold engine):
Dry Weight: 8,5 kg / 18.7 lbs
Bore x Stroke: 60 x 40 mm

BEFORE STARTING ENGINE

ADD OIL
Your engine is shipped without oil in it. For type/grade of
oil to use, see the Maintenance section of this manual.
CAUTION: Fill engine with oil before starting.
1.
Be sure engine is level.
2.
Remove oil fill cap from oil fill spout.
3.
Engine holds 0,45L (15.5 oz) of oil. Pour oil slowly.
Do not overfill. Wait one minute to allow oil to settle.
Use gauge on oil fill cap/dipstick for checking level.
Insert dipstick into the tube and rest the oil fill cap
on the tube. DO NOT thread the cap into the tube
when taking reading.
4.
Insert and tighten oil fill cap/dipstick.
Oil fill cap /
dipstick
Upper
mark
Lower mark
IMPORTANT:
Check oil level before each use. Add oil if needed.
Fill to upper mark on dipstick.
Change the oil after every 20 hours of operation.
You may need to change the oil more often under
dusty, dirty conditions. See "TO CHANGE ENGINE
OIL " in the Maintenance section of this manual.

PRODUCT SPECIFICATIONS

0,8 L (0.85 Quarts) (Unleaded Regular)
0,45 L (15.5 oz)
SAE 30: 5°C (40°F) and higher
SAE 10W-30: -18 to 38°C (0 to 100°F)
SAE 5W-30: 5°C (40°F) and below
Torch A5RTC (Gap: 0,6–0,8 mm)
Intake: 0,13–0,17 mm; Exhaust: 0,18–0,22 mm
Displacement: 113 cc
Net Power: 1,6 kW @ 3,060 RPM

PRE-OPERATION

25

ADD GASOLINE

Fill fuel tank to bottom of tank filler neck. Do not
overfill. Use fresh, clean, regular unleaded gasoline
with a minimum of 90 RON (87 AKI)octane. Do not
mix oil with gasoline. Purchase fuel in quan ti ties
that can be used within 30 days to assure freshness.
Fuel tank
Gasoline filler cap
CAUTION: Wipe off any spilled oil or fuel. Do not
store, spill or use gasoline near an open flame.
CAUTION: Alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract moisture which
leads to separation and for ma tion of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage. NOTE: Gasoline containing up to 10%
ethanol (E10) is acceptable for use in this machine. The
use of gasoline exceeding 10% ethanol (E10) will void
the product warranty. To avoid engine problems, the fuel
system should be emptied before stor age of 30 days or
longer. Empty the gas tank, start the engine and let it run
until the fuel lines and carburetor are empty. Use fresh
fuel next season. Never use engine or carburetor cleaner
products in the fuel tank or permanent damage may occur.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents