Sensor Quick View Of Parameters - Honeywell XYR 6000 User Manual

5. 4BOperation

5.4. Sensor Quick View of Parameters

Sensor display Wireless Builder display
E FAIL* RAM Fault*
INP FAIL Input Failure
INP FAIL A/D Failure
The following statuses are displayed only in Wireless Builder Device Status.
blank* Device/Firmware
Mismatch*
blank* Heap Memory Not
Available*
blank* Watchdog Timer Error*
5.4 Sensor Quick View of Parameters
If you press the up or down arrow key during the PV display, the following quick view parameters are
shown sequentially, then the PV display resumes.
Sensor type
Tag
Serial number
Device revision
26 OneWireless XYR 6000 Wireless Valve Position Sensor User's Manual
Definition
Parameter
Startup diagnostics
detected defect in
Processor Random
Access Memory
Input Error
Diagnostics detected
defect with Analog to
Digital Converter.
Sensor Board Firmware
Error. The software did
not pass verification
tests.
Heap Allocation Failure.
Software detected heap
shortage and some
communication packets
may have been dropped.
Sensor Watchdog
Timeout. The processor
was restarted due to
unexpected operation.
Description
HONEYWELL WCX Valve Position
Sensor
The name given to this sensor
Sensor serial number. This is the WBSN
on the sensor's nameplate. Do not
confuse this with the other nameplate
item marked "Serial."
This parameter changes whenever
objects and parameters are added,
deleted, or the data type or range
changes. It does not change if the
What to do
Sensor module must be replaced..
Check potentiometer connections.
Verify that slip clutch is properly
engaged with input shaft. Check
slip clutch operation.
Restart the sensor. If condition
persists, sensor module must be
replaced.
Sensor module must be replaced.
Sensor module must be replaced.
Clear by warm restart of device. If
condition persists contact
Honeywell service.
Clear by warm restart of device. If
condition persists contact
Honeywell service.
Revision 1
1/15/09