Honeywell XYR 6000 User Manual page 35

Sensor display Wireless Builder display
OUT SVC OOS
CAL ERR Calibration Error
CFG ERR Configuration Error
LOW BAT Low Battery
NO RADIO Radio Interprocessor
Comm Error
BAD RADIO Sensor Radio SPI
SPI Communication Failure
BAD RADIO EEPROM SPI
EEPROM Communication Failure
RADIO WDT WDT Reset Occurred
RESET
BAD RADIO Radio Circuitry Failure
The following status messages have multiple meanings. Refer to Wireless Builder Device Status for exact cause.
E FAIL A/D Failure
E FAIL Electronics Failure
E FAIL* NVM Fault*
E FAIL* Program Memory Fault*
Revision 1 OneWireless XYR 6000 Wireless Valve Position Sensor User's Manual
1/15/09
Definition
All channels are out of
service.
Calibration Data Invalid
or could not be read.
Configuration Check
Error.
Battery Voltage Critically
Low
Radio Board is not
accessible.
Radio detected loss of
communication with
sensor board over the
inter-processor
communication link.
Radio EEPROM SPI
Communication failure
Radio Watch Dog
Timeout detected
Radio circuitry has failed
Diagnostics detected
defect with Analog to
Digital Converter.
Electronic Failure
detected on Sensor
Board. Could be caused
by one of the status
items marked by *.
Startup diagnostics
detected defect in
Sensor Non-Volatile
Memory
Startup diagnostics
detected defect in
Sensor Read Only
Memory
5. 4BOperation
5.3. Sensor PV Display
What to do
Restore mode to Auto in Wireless
Builder.
Use Cal Clear, Restore, or User
Calibrate.
Database is corrupted. Cold start
and reload configuration.
Replace batteries as soon as
possible. See page 36.
Restart both the radio and sensor.
If condition persists, sensor
module must be replaced.
Restart both the radio and sensor.
If condition persists, sensor
module must be replaced.
The radio will not be able to
perform firmware upgrades but will
operate normally using installed
code. Sensor module should be
replaced.
Restart both the radio and sensor.
If condition persists, sensor
module must be replaced.
The radio processor detected error
on internal radio circuitry. Sensor
module must be replaced.
Sensor module must be replaced.
Restart both the radio and sensor.
If condition persists, sensor
module must be replaced.
Sensor module must be replaced.
Sensor module must be replaced.
25