Table of Contents
Advertisement
I. Power Cord
1. Prior to installing the power cord, turn the dial
control "OFF".
2. Make sure the wall receptacle has 120vac
output. NOTE: Using a circuit protector can
protect the appliance circuits from power
surges.
3. Remove the right side panel by releasing the
upper, spring-loaded latch. Access the latch
through the upper panel vent holes. The cast
panel should fall forward. Lift it out of its lower
nest and set the panel aside. You may need
to disconnect the dial control wire harness.
4. Connect the power cord to the appliance first.
5. Route cord behind panel set.
CAUTION
Shock Hazard
- Do not remove grounding prong from plug
- Plug directly into properly grounded & prong recep-
tacle.
- Route cord away from appliance
- Do not route cord under or in front of appliance
January 4, 2018
J. Trim Adjustment
Figure 23.1
Trim adjustment is the small dial located below
the main dial control. The function of the trim adjust-
ment is to allow for variations in elevation, venting
and installation configurations, and fuel types (hard
wood/soft wood).
Rotating this dial will adjust the air/fuel ratio to the
appliance:
•
Clockwise adjustments increase the flame
height.
•
Counter-clockwise adjustments will
decrease the flame height.
•
When changing trim settings only adjust 1
level at a time, allowing 15 minutes for fire to
stabilize before making another adjustment.
•
The factory default trim adjustments are set
to zero (0) for most fuels and recommended
venting configurations.
A properly adjusted fire will have a bright, active
flame pattern that extends out of the fire pot approx-
imately 6 to 9 inches when burning on high. A prop-
erly adjusted fire will burn cleaner and have higher
efficiencies. Please copy and paste the follow web
address: http://www.quadrafire.com/Owner-Re-
sources/Use-and-Care-Videos/Mt-Vernon-E2-Pel-
let-Stove-Insert.aspx and watch the video regarding
Normal Operation.
7082-150C
MT VERNON E2 INSERT-C
23
Advertisement
Table of Contents
